bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Aliner Ranger 12 Camper


  • Recommended RV Cover For A 2018 Aliner Ranger 12 Pop-Up Camper
  • For your 2018 Aliner Ranger 12 Camper I recommend the Adco Polypropylene RV Cover for Pop-Up Camper # 290-2894. This polypropylene cover is rated for use in all climates, as you can see in the attached climate map. It is constructed of a lightweight non-abrasive fabric that protects against moderate sun, dust, and water and won't scratch the buddle window on the roof of your camper. The cinch ropes at the front and rear of the cover remove slack and reduce billowing and the weighted straps...
    view full answer...

  • Can 175/80-13 Radial Tires be Used on the Same Rim as 175/80-13 Bias Tires
  • The only difference between your current Loadstar tires and the Karrier ST175/80R13 Radial Trailer Tire - Load Range D # AM10210 is going to be bias vs. radial and potentially a different load rating. When it comes to size, these tires will be the same and will fit on the same rims you already have. The Karrier # AM10210 has a maximum load of 1,650 lbs at 70 psi and a max speed of 81 mph. This radial ply tire is designed for trailers towed on the highway giving you longer tread life and...
    view full answer...

  • Comparing Radial Vs Bias Ply Tires
  • There are a few advantages and disadvantages when deciding between bias ply # AM3S334 and radial tires # AM31994. With radial tires, some advantages would be: 1. Improved comfort. 2. Superior heat management and heat dissipation. 3. Excellent tire flexibility and road surface interaction. 4. Superior handling. 5. Lower rolling resistance. Compared to some bias ply tires benefits: 1. Less complicated tire construction and, therefore, typically lower cost. 2. The stiffer sidewall can be...
    view full answer...

  • Recommended Replacement A-Frame Jack For A 2021 Aliner Ranger 12
  • The Pro Series Round, A-Frame Jack # PSRV20000103 will definitely definitely fit in frame as the 3" triangular bolt pattern is a standard, but I cannot 100% say that your existing wheel will fit. It most likely will, but I do have an option that I can 100% say will work. The etrailer.com Round A-Frame Trailer Jack # TJA-5000T-B is a RAM jack, though this will be a little more heavy duty than your original one. It will have a 5,000 pound support capacity, a 3,000 pound lifting limit, and...
    view full answer...

  • Troubleshooting Curt Echo Mobile Brake Controller that Required Higher Settings Second Use
  • Is it possible the brakes on the camper are self-adjusting and were new? This is a common problem where they aren't fully adjusted so they take a higher brake controller setting but as they tighten with each application they eventually feel more and more touchy/powerful with every application so you end up needing to lower the brake controller output settings. With the lower brake output settings do the brakes seem to react smoothly? Or do they lock up immediately? If they lock up immediately...
    view full answer...

  • Retracted and Extended Height of Dutton Lainson Trailer Jack DL22530
  • The retracted height of the Dutton Lainson Trailer Jack # DL22530 is 8-1/4 inches and the extended height is 23-1/4 inch. From the mounting bracket to the top of the jack measures 15-1/4 inches.
    view full answer...

  • Ceiling Garnish Options for Fan-Tastic Vent Upgrade Kit Compatibility
  • The Fan-Tastic Vent 7350 Series Upgrade Kit - High/Low Style Base - White # FV807359 you asked from will allow you to use a ceiling garnish in the depth you desire on the bottom but the top will not require any changes at all.. We have the 6 inch ceiling garnish in white # FVK1060-81 or off-white # FVK1060-80 which can be cut down. The Garnish for Fan-Tastic Vents Roof Vent - 4-1/2" Leg - 14-1/4" x 14-1/4" - Off White # FVK2040-80 is also an option. I've linked the page to all the...
    view full answer...